Ecoair apollo 12000btu User Manual - Quick Set Up
© 2016 EcoAir 13 All rights reserved
En
gli
sh
SET BUTTONS
Under cooling mode, press "+" or "-" button to increase or decrease set temperature by 1 °C.
Set temperature range is between 16°C - 30°C. Under auto, drying or fan mode, this button is
invalid.
QUICK SET UP
FAN BUTTON
Press this button to select:
Low
Medium
High
Auto
These fan speeds can be selected in cooling and fan modes only.
SLEEP BUTTON
TIMER BUTTON
Press this button to set timer. To adjust timer, press set buttons.
Timer can be set for up to 24 hours.
Wait 5 seconds after setting the time, for the display to show the set temperature.
During the timer setting, make sure there is no more than 5 seconds delay between sets, other-
wise the remote control will cancel setting status.
To cancel set timer, press timer button twice.
Note: Select the mode before you select the timer.
The timer can be set for:
While the appliance is ON, the timer can be set to switch off after your set time.
While the appliance is OFF, the timer can be set to switch on after your set time.
Press this button to select sleep mode. (Works in Cooling and Dry Mode only)
The preset temperature will increase by 1°C after the first hour.
The preset temperature will increase by 2°C after two hours. The appliance will operate in this
temperature until it is switched off.
Use this mode for bedtime, the appliance will reduce the cooling as you fall asleep since our
body temperature tends to come down during that period.