Ecoair ECODC202 User Manual - To Empty The Bucket
TO DRAIN WATER (Continuous Drainage)
You may use a hose with an inner diameter of 12mm for
continuous drainage:
1. Use a screwdriver to remove the knockout at the back. Attach
the hose to the connector through the hole.
2. The hose must lead to an appropriate drain at a downward
slope with no sharp bends.
TO EMPTY THE BUCKET
1. When the bucket is full, the "FULL" LED light will illuminate and the unit will stop.
2. Do not move the unit or remove the bucket, if the machine is still operating, as
water may leak, damage the unit or cause an electric shock.
3. To remove the bucket, pull it out gently by gripping the bottom of the bucket,
and lift carefully. (Turn off for 5 minutes before empty the bucket.)
4. Pour the water away, clean the bucket and restore the bucket to the correct position.
NOTE :
Clean the bucket with clean water if needed. Do not use detergent, solvent, abrasive
or hot water to avoid damage to the appliance.
Do not remove or damage the float in the bucket, the unit will not
work correctly.
The "FULL" LED light will stay on until the bucket is restore to the correct position.
Knockout
Hose
9
Note:
1. Ensure the bucket is well fitted in position before inserting the hose.
2. Before removing the bucket, ensure that the hose is
disconnected
.