Ecom EN2-F Quick Manual - page 4
Page 4
Remote display (ECOM-R)
Connection with ECOM analyzer
(The ecom-R connects with only 1 analyzer at a time)
Unpair Bluetooth Connection
- Hold the red key (approx. 5 sec.) until
“
Unpair:
”
appears
- When
“Unpair: OK”
is shown, the connection is deleted
Analyzer must have Bluetooth option!
(wireless range is approx. 10 m)
Setup Bluetooth Connection
- Ensure there is only one instrument with Bluetooth near the ecom-R
- Turn on the analyzer
- Go to Adjustments
Internal
Bluetooth and select Protocol-
Enhanced
- Turn on ecom-R & wait while the Bluetooth connection is made
automatically
*Change display:
Choose line
Adjust line
Set adjustment
Exit adjustment
Change display* (see below)
Start printout
(4 displays)
Choose display screen
Switch on/off ecom-R
(hold approx. 1 sec.)
READY = Connection is active
CALIB = Analyzer in calibration phase
WAIT = Searching for connection
Battery voltage