Ecom Ident-Ex 01 Operating Instructions Manual - page 22
22
After these 2 seconds you can release the Main Trigger and SPP button, too.
The Bluetooth LED should start to flash to indicate that the Bluetooth module of
the Ident-Ex is in test mode. In order to leave the Bluetooth test mode you must
power off the Ident-Ex (Press and hold the Power button until the Power LED is
off).
Continuous Read
Reading with the Ident-Ex and its head module can be made continuously. Con-
cerning this the SPP button must be hold while powering up the Ident-Ex.
Ensure that the Ident-Ex is powered down. Press and hold the SPP button. To
power up the Ident-Ex press and hold the Power button until the Power LED is
on. When the Power LED is on you can release the Power button. Still hold the
SPP button for about 2 seconds. After these 2 seconds you can release the SPP
button, too. The Ident-Ex should start to read continuously. You don’t have to
start reading via pressing the Main Trigger or Trigger button. In order to stop the
continuous reading you must power off the Ident-Ex (Press and hold the Power
button until the Power LED is off).
Bluetooth Testmode and Continuous Read
Chapter Bluetooth Testmode and chapter Continuous Read describe how to
bring the Bluetooth module into test mode or how to do a continuous read with a
head module. In this chapter it is described how to do this combined. There is a
possibility to bring the Bluetooth module into test mode and to do a continuous
read with a head module at the same time. Concerning this the key combination
Main Trigger + Trigger button must be hold while powering up the Ident-Ex.
Ensure that the Ident-Ex is powered down. Press and hold the Main Trigger and
the Trigger button. To power up the Ident-Ex press and hold the Power button
until the Power LED is on. When the Power LED is on you can release the Power
button. Still hold the Main Trigger and the Trigger button for about 2 seconds.
After these 2 seconds you can release the Main Trigger and Trigger button, too.
The Bluetooth LED should start to flash to indicate that the Bluetooth module
of the Ident-Ex is in test mode and the Scan LED starts to flash to indicate that
reading is running.