Ecom Loc 01 User Manual - page 4
of
8
4
!Please use the Blue Giga / Silabs tools for firmware flashing because Blue Giga is
using an own scripting language which is not fully compatible with TI´s C language.
3. How to connect the Debugger with the Development Board
1. Connect the Debugger with the Converter Board 2,54mm- 1,27mm connector.
2. Connect one side of the 10 pin flat cable with the Converter Board.
3. Connect the open end of the 10 pin flat cable with the Development Board.
Pin 1 = GND
4. Using The BLE Update Tool and start an Firmware Upgrade
After starting the tool and a debugger with a connected Development Board please
proceed as below :
Press the reset Button on the Debugger. The info LED should now switch from red
to green light.