Ecomiser SU-01 Manual - page 11
NOTE
- No portion of a wall drain system may be higher than 18
”
(457mm).
- No part of the drain hose should be higher than 20
”
(508mm) from the bottom of the dishwasher.
- Failure to provide the proper drain connection height (maximum of 20
”
(508mm)) above the bottom of
the dishwasher base) will result in improper drainage.
- After connecting the drain hose to main drain line, make sure all connections are water tight.
4. DISPENSING SYSTEM CONNECTION
The Ecomiser SU-01 / SU-02 Models are designed for use with a liquid rinse aid and detergent. The
Ecomiser SU-01 / SU-02 Models equipped with liquid internal detergent and rinse aid pumps each
have a tube exiting the machine at the lower rear. These tubes can simply be attached to detergent and
rinse aid containers.
- Commercial (not a domestic) detergent must be used.
- Locate the red liquid detergent and blue liquid rinse aid tube at the lower rear of the machine.
Connect the tubes to the detergent and rinse aid container.
Figure 3-4 Liquid rinse & detergent injection
- This figure shows you how tubes are to be connected to
detergent / rinse containers.
a) Make a hole about 3mm bigger than the tube diameter
on the container cap (No. 1)
b) Insert the tube through the container cap into the sinker
cap (No. 2)
c) Tighten the sinker cap on to the sinker (No. 3)
d) Drop the sinker down to the bottom of the container to
supply chemical properly.
Ecomiser SU-01 / SU-02 Manual 11/21 Page Rev.05