Ecomiser SU-01 Manual - page 13
CONTROL SYSTEM
A) The left display
- Temperature inside wash tank
- Set mode (when pushing the mode key)
B) The right display
- Temperature inside rinse tank
- Setting data (time, temperature)
- Error code
C) LED
- Ready: The light is on when wash mode is ready to be started with the temperature 180
℉
(82
℃
)
inside rinse tank after the first run. The first run will be started after satisfying programed
temperature (washing tank 140
℉
/60
℃
, rising tank 203
℉
/95
℃
). It takes about one hour depending
on incoming water temperature.
- Water: The light is on when supplying water.
- Heater: The light is on when the heater is operating.
- Operating state: Each light is on when indicating the present working (washing, detergent supply,
waiting, rinsing, rinse supply, completion of work)
- Temperature unit (C:
℃
, F:
℉
)
D) Key
Use these buttons when you want to operate the machine.
- POWER
1) Power On/Off
2) All activation will be stopped when power off.
3) When canceling error messages.
- START/STOP
1) When starting or stopping the washing operation.
2) In state of [PAU], if you try to push any key, the keys operation will not function.
- MODE KEY
1) When push holding the key 1 time, it is possible to change the washing time after about 6
seconds.
2) Push again 1 time after window changes
detergent incoming time (Minimum. 3 seconds)
3) 2 times
waiting time
4) 3 times
rinsing time
5) 4 times
rinse incoming time (Minimum. 3 seconds)
6) 5 times
heater control temperature (high)
7) 6 times
heater control temperature (low)
8) 7 times
buzzer on or off
9) 8 times
temperature unit (
℃
,
℉
)
10) 9 times
drain time
11) 10 times
model type (door, under)
12) 11 times
completing (early mode)
Ecomiser SU-01 / SU-02 Manual 13/21 Page Rev.05