ECOPURE EP100 Installation And Operation Manual - page 12
12
FIG. 17
UP button
Display
RECHARGE button
SELECT button
DOWN button
FIG. 16
When the power supply is plugged into the electrical
outlet, a model code and a test number (example:
J2.0), begin to flash in the faceplate display. Then,
“12:00 PM” and the words “PRESENT TIME" begin to
flash.
NOTE:
If “- - - -” shows in the display, press the
p
UP
or
q
DOWN button until the model code
(“o30” for Model EP100) shows in the display.
Then, press the SELECT button to set, and
change to the flashing “PRESENT TIME" dis-
play.
SET TIME OF DAY
If the words “PRESENT TIME" do not show in the dis-
play, press the SELECT button until they do.
1
. Press the
p
UP or
q
DOWN buttons to set the
present time. Up moves the display ahead; down
sets the time back. Be sure AM or PM is correct.
NOTE:
Press buttons and quickly release to slowly
advance the display. Hold the buttons down
for fast advance.
FIG. 18
SET WATER HARDNESS NUMBER
1
. Press the SELECT button once again to display a
flashing “25” and the word “HARDNESS”.
2
. Press the
p
UP or
q
DOWN buttons to set your
water’s hardness number.
NOTE:
If your water supply contains iron, compen-
sate for it by adding to the water hardness
number. For example, assume your water is
20 gpg hard and contains 2 ppm iron. Add 5
to the hardness number for each 1 ppm of
iron. In this example, you would use 30 for
your hardness number.
20 gpg hardness
2 ppm iron x 5 = 10 +10
(times)
30 HARDNESS NUMBER
NOTE:
If you use potassium chloride (KCl) salt
instead of sodium chloride (NaCl) salt in this
softener, increase the hardness setting by
25%. For example, if you will be using KCl
and your water supply’s hardness is 20 gpg,
set the softener to 25 gpg.
Programming the Water Softener
(Model EP100)