Ecosoft MO 5-100 Installation And Operation Manual - Note
12
Before installing the system, it is necessary to prepare a place under the kitchen sink. Make sure
that there is sufficient space for the system and the pressure tank. In case there is not enough
empty space under the kitchen sink it is acceptable to install the pressure tank separately from
the system within yellow tube stretching distance.
Note
It is preferable to install the system in places protected from direct sunlight.
1. Remove the RO system from its packaging and check the assembly.
2. Shut off water supply in your kitchen or whole home and open water tap where you are
about to install the system (on your kitchen sink) for 1 minute to relieve pressure in the system,
and then close it.
3. Install the feed adapter into the cold water line, take feed water valve from the set and join
it to the feed adapter.
Note
Feed adapter is ½
″ sized. If your pipe is a different size, use an appropriate reducer
fitting.
4. Unscrew the coupling nut of the feed water valve connection and put it on the red tube.
Insert the red tube into the outlet of the valve and screw the coupling nut back on. Connect
the other end of the red tube to the quick connect fitting of the first pre-filter.
5. Connect the drain saddle with drain pipe from the kitchen sink. The drain saddle is
compatible with most standard drain pipes. Drill a hole of 5,0 mm diameter in the kitchen sink
drain pipe, apply rubber gasket with sticky base (included in the kit). Install the drain saddle
on the drain pipe over the hole. Tighten nuts on drain saddle with a wrench. Insert black tube
into the connection on the clamp (figure 4). For instruction on using quick connect fittings,
read chapter 6.
6. Put a few turns of PTFE tape on the thread on tank outlet. Screw the tank valve onto the tank
outlet. Close the tank valve.
7. Install the faucet according to the instructions in chapter 5.
8. Select spot where you are going to install the filter and make two holes. The distance
between the holes in the wall must precisely correspond to that between the holes in the
bracket. Allow for at least 100 mm gap between the bottom of the filter and floor. Install screw
Figure 4