Ecosoft MO 5-100 Installation And Operation Manual - Caution
21
6. Remove the used membrane (note its orientation and position inside).
7. Grease new membrane’s rubber sealing rings and membrane housing sealing ring with
silicone grease.
8. Install the new membrane into the housing, observing orientation as per step 6.
9. Screw on the membrane housing cap.
10. Connect the tube to the inlet in membrane housing cap.
11. Close the faucet.
12. Open the pressure tank valve.
13. Open the feed water valve.
14. When the tank is full (and water stops flowing through the system) drain all the water
from the tank into the kitchen sink by opening the faucet.
15. When water pressure is released, close the faucet to refill the tank. Depending on supply
water pressure, filling the tank can take from 1,5 to 3 hours. When the tank has been
refilled for the second time, drinking water may be used.
Carbon post-filter replacement procedure
Caution
Wash your hands thoroughly with antibacterial soap before performing any maintenance
on your filter. Only use clean tools and make sure to sanitize the workplace beforehand
using detergent or bleach.
1. Close the feed water valve.
2. Close the tank valve (by turning it 90°)
3. Open the faucet to release the pressure.
4. Pull out the tubes connecting the post-filter to adjacent units.
5. Remove the used filter from the plastic brackets.
6. Install the new post-filter in place of the expired one observing the flow direction as
indicated by the arrows.
7. Connect the post-filter back to the union tee(s) and the faucet (step 4 in reverse).
8. Open the faucet. Open the pressure tank valve.
9. Flush water to the drain for 10-15 minutes.
10. Close the faucet.
Re-mineralizing filter replacement procedure
Caution
Wash your hands thoroughly with antibacterial soap before performing any maintenance
on your filter. Only use clean tools and make sure to sanitize the workplace beforehand
using detergent or bleach.