ECOVACS DEEBOT D77 Instruction Manual - page 8
Package Contents and Technical Specifications
2.4 LCD and Control Panel
8. Pause Status
9. Spot Cleaning Mode
10. Return to Charger Mode
11. Edge Cleaning Mode
12. Intensive Cleaning Mode
13. Automatic Cleaning Mode
14. Operation Status
15. Cancel Scheduled Cleaning
16. Daily Scheduled Cleaning
17. One Time Scheduled Cleaning
18. Time Adjust Button
19. Set Cleaning time
20. Current Time Setting Status
21. Time display
1. Battery Display
2. Indicator - Dust Box Full
3. Indicator - Dust Box Missing
4. Indicator - Trapped Item
5. Indicator - Driving Wheel Suspended
6. ON/Pause
7. Mode Selection
Model D77
2.5 Remote Control
Start/Pause Button: start or pause the robot.
Direction Control Button: push and hold the appropriate button to drive the
robot in any direction.
Mode Selection Button: according to conditions, choose different cleaning modes
(please refer to section 3.3 “mode selection”).
Please make sure the Remote
Control’s batteries are properly
installed and power switch at
the bottom of the robot is ON.
Remove batteries if Remote
Control will not be used for
a long time.
During direction control, the
robot is not able to clean.
When using the Remote
Control, be sure to point it
towards the infrared signal
receiver on the robot, and be
within 16 feet of the robot.
The charging dock or other
sources that use an infrared
signal may interfere with the
Remote Control signal.
Note
Mode
7