ECOVACS winbot 7 series Instruction Manual - page 13
12
6. Day-to-day Storage
●
Store the Winbot in the original box, in a cool, dry place to protect electronic
components.
●
Do not store the Winbot close to liquids or where the liquid might be spilled onto
it.
●
Abide by maintenance requirements for the unit as described in Section 7 of this
Instruction Manual.
7.1 Cleaning the Unit
7. Product Maintenance
●
Before cleaning the Winbot, move the switch under the handle to the OFF
position (far left) and unplug it from the electrical source.
●
Clean the top of the Winbot with a damp cotton cloth.
●
Do NOT clean the Unit with any volatile liquid, solvent, or a detergent containing
acidic ingredients as they can damage the plastic.
7.2 Cleaning and Replacing Cleaning Pads
●
After each cleaning cycle, or if the Cleaning Pads become very dirty, they can be
rinsed in clear warm water and allowed to dry completely (generally 24 hours)
before re-attaching. The Cleaning Pads are also machine washable. An
additional set of Cleaning Pads may be purchased by calling Customer
Service at 1-888-966-0895 or visit www.ecovacs.com.
Live Smart. Enjoy Life.
7.3 Squeegee
●
After each use, gently wipe the Squeegee on the bottom of the unit with a damp,
not wet, cloth to remove residue from its surface. (A wet cloth will allow water to
get inside the unit and cause damage to the internal components.)
7.4 Cleaning Driving Treads
NOTE: Dirty Driving Treads can negatively affect the function of the treads
guiding the unit on the window.
●
After each use inspect the Driving Treads for possible accumulation of dirt. The
entire Driving Tread can be inspected by using the Remote Control and
pressing the Forward or Reverse arrow. Clean any dirt with a soft damp cloth.
EN