EcoWater EPS 1000 Operation & Installation Manual

Manual is about: Purification System

Summary of EPS 1000

  • Page 1

    Ecowater purification system eps 1000 u safety guides u installation u operation u maintenance u repair parts ecowater systems llc 1890 woodlane drive woodbury, mn 55125 www.Ecowater.Com 7307445 (rev. M 6/17/15) system tested and certified by nsf inter national against nsf/ansi standards 42 and 53. ...

  • Page 2: Table Of  Contents

    Table of contents warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2 what the drinking water system will do . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ....

  • Page 3: Safety Guides

    3 safety guides q read all steps and guides carefully before installing and using your undersink drinking water filter system. Follow all steps exactly to correctly install. Reading this manual will also help you to get all the benefits from the undersink drinking water filter system. Q do not use f...

  • Page 4: Components Of The System

    Components of the system materials and tools needed typical undersink installation • filter system assembly • color coded 3/8” od tubing to make all needed connections • parts bag containing mounting washers and screws • filtered water faucet assembly, packaged separately note: gather the required t...

  • Page 5: Installation Steps

    Installation steps step a - feed water supply fitting 1. Close the hot and cold water shutoff valves that are immediately upstream of where you will install the feed water supply fitting. Open faucet(s) to drain water from the sink cold water pipe. 2. Check and comply with local plumbing codes as yo...

  • Page 6: Installation Steps

    6 installation steps step c - install faucet (packaged separately) 1. Slide the chrome base over the faucet stud so that it will sit below the faucet body (see fig. 3). 2. Remove the hex nut from the end of the stud. Slide the spacer and lock washer onto the stud. Place the hex nut back onto the stu...

  • Page 7: Installation Steps

    7 installation steps continued from the previous page to disconnect tubing: 1. Push the collet inward and hold with a finger while pulling the tubing out. Figure 5 tubing collet (depress to remove tubing) figure 4 connect tubing: 1. Use a sharp cutter or knife to cut the end of tubing square. 2. Ins...

  • Page 8: Filter Cartridges

    8 filter cartridges filter cartridge life filter cartridge replacement (replace filter cartridges every six months) lead, chlorine taste and odor, and purifying filter cartridges: lead, chlorine taste and odor, and purifying filter cartridges contain activated carbon. When new, open the filtered wat...

  • Page 9: Troubleshooting The System

    9 troubleshooting the system problem: no water flow or decreased water flow. Cause: prefilter is clogged. Correction: replace the prefilter cartridge. Cause: flow through the purifying filter will decrease and eventually clog when exposed to an excess of microbiological loading materials in the wate...

  • Page 10: Exploded View

    10 10 exploded view 1 11 4 8 4 8 5 6 7 2 3 9.

  • Page 11: Repair Parts List

    11 repair parts list key no. Part no. Description 1 7268382 cover (2 req’d) – 7333129 mounting hardware kit (includes 2 ea. Of key nos. 2 & 3) 2 á hanger washer (2 req’d) 3 á screw (2 req’d) 4 7168435 tubing, 3/8” od x 72” long, white 5 6002900 head assembly 6 7320697 repl. Filter cartridge, lto (le...