EcoWater EPS 1000 Operation & Installation Manual - Components Of The System
Components of the System
Materials and Tools Needed
Typical Undersink Installation
• Filter system assembly
• Color coded 3/8” OD tubing to make all needed connections
• Parts bag containing mounting washers and screws
• Filtered water faucet assembly, packaged separately
NOTE: Gather the required tools before starting installation. Read and follow
the instructions provided with any tools listed here.
• Slotted and Phillips screwdrivers
• Pliers and adjustable jaw wrench
• Tubing cutter
• Electric drill and 1-1/4" drill bit if mounting hole is needed for the faucet
IMPORTANT: To avoid damaging the sink, consult a qualified plumber or
installer for drilling procedures in porcelain or stainless steel.
Locate the water filter housing on the cold water supply pipe, under the kitchen and/or bathroom sink, to
filter the cold drinking water. Refer to the following drawing.
shutoff valve
filtered
water faucet
purifying
filter
prefilter
Blue tube
WATER
OUT
Yellow tube
WATER
IN
supply fitting
SINK
NOTE: Be sure to allow a minimum
space of 1-1/2" under the system
for removing the filter cartridges, in
order to change the cartridges.
Figure 1
4-1/4”
COLD
HOT
4
Installer Provides
• Fitting(s) to tap the cold water pipe for a feed water source to the filter
assembly . . . must adapt to 3/8” OD tubing