EcoWater ERO-375 User Manual - page 13
13
CONNECT THE HYDROLINK™ RO MODULE TO THE REMOTE (Model HERO-375 Only)
Hydrolink™
RO Module
FIGURE 10
CONNECT button
(push with ball point pen)
NOTE:
If you do not have a Hydrolink
™
-equipped
water conditioner (with remote), skip this procedure.
The RO electronics and the indicator light on the faucet
base will function normally, as described on Page 18.
1.
Locate the remote for your Hydrolink
™
-equipped
water conditioner or refiner. From any of the rolling
status screens, press the SELECT (
) button to display
a
menu
.
2.
Press the remote’s DOWN (
) button to scroll
through the menu options until
Add new device
is
highlighted.
4.
Using a ball point pen or similar probe, press the
CONNECT button on the Hydrolink™ RO Module
(See Figure 10) and hold it down for at least two sec-
onds, until the LED on the Hydrolink™ RO Module
begins to flash, then release.
5.
When the remote detects a signal from the
Hydrolink™ RO Module, the display will change to
show the following screen.
3.
Press the remote’s SELECT (
) button, and the
screen shown below is displayed. The remote waits
two minutes for the Hydrolink
™
module to be activat-
ed (as described in the next step).
6.
If another message appears instead, indicating a
device was not added successfully, press the remote’s
LEFT (
) button to return to the screen shown under
Step 2. Repeat Steps 3 and 4.
POSITION HYDROLINK™ RO MODULE UNDER RO COVER (Model HERO-375 Only)
FIGURE 12
Line up when placing Hydrolink™
RO Module under cover
Cover
Hydrolink™
RO Module
1.
Place the Hydrolink™ RO Module into the RO
manifold assembly, where shown in Figures 11 & 12.
Route the wire as shown in Figure 11 and carefully
push it down into the recesses on the manifold assem-
bly while holding the Hydrolink™ RO Module in
place.
2.
Snap the cover onto the RO manifold assembly,
making sure that the Hydrolink™ RO Module is lined
up as shown in Figure 12.
FIGURE 11
Route wire
as shown
Hydrolink™
RO Module