EcoWater ESM11+ Owner's Manual - page 3
Information at your finger tips
Please note at each press of the button the softener will beep, this is normal.
Please note that the
out of salt days can vary depending
upon your day to day usage.
*Water remaining before the next recharge.
Normal operation / Status screens
During normal operation, the unit displays status
screens in an automatic sequence:
Other messages, alerts & reminders
4
5
If you make an error in your selection, just proceed
through the menu options to the end where your
required screens will be available again and you
will have the option to reselect.
Salt status (NaCI)
Out of salt in
135 days
14:32
Water use (liters)
Daily average: 625
Today: 456
*Remaining: 2380
14:32
Recharge status
Set for automatic
recharge
14:32
Water flow
14:32
0.0 LPM
Display
LEFT
Button
UP
Button
RIGHT
Button
E.A.S.E.
Port
SELECT
Button
DOWN
Button
The status screens described on the previous page
will
not
be displayed when one of the following is displayed:
•
Recharge status
(Displayed during recharges,
showing valve position and time remaining).
•
Add salt
or
Out of salt
indicates salt needs to be
added and the salt level reset (see below).
•
Current time
setting screen instead of status
screens indicates time needs to be set (Page 6).
•
Service reminder
(Contact your Ecowater Agent)
•
Error detected
(Contact your Ecowater Agent)
ADDING SALT & SETTING SALT LEVEL
When salt is required the rolling screen will stop and
an animated bell symbol will be displayed.
Open the salt lid, replenish with salt being careful not
to exceed the highest visible number at the top of the
yellow decal on the side of the black vertical tube and
note the lowest visible number you can see. Close the
salt lid.
TO RESET THE SALT ALARM
Press SELECT
button. Press DOWN ( ) to highlight
‘Salt settings’. Then press ‘Select’ Highlight ‘Salt level’
and press SELECT
button.
Press DOWN ( ) or UP ( ) buttons to match the salt
level on the yellow decal just noted. Press SELECT
button to confirm.
Press LEFT ( ) button twice to return to main menu
(with rolling screens).
If you do not wish to use the Salt Alarm feature it can
be disabled. Please discuss with your EcoWater Agent.
Please Remember
–
Only use tablet or pellet salt in your softener!
Please Remember
–
Only use tablet or pellet salt in your softener!
Recharge
Salt settings
Basic settings
Main menu
Salt level
Low salt alarm
Salt type
Salt settings
Salt level
4