Ecox EAEM Owner's Manual - page 7
7
REMOTE CONTROL
SPLIT AIR CONDITIONER
EAEM
OPERATION MODE Indicator: When press the MODE button, it shows the current
operating mode - “AUTO", "COOL”, "DRY" "HEAT"(Cooling only model without) or
"FAN" mode.
LOCK Indicator: LOCK display is displayed by pushing the LOCK button Push the
LOCK button to clear display.
TIMER DISPLAY Indicator: This display area shows the settings of the TIMER. That
is, if only the starting time of operation is set, it will display the TIMER ON. If only the
turning off time of operation is set, it will display the TIMER OFF. If both operations
are set, it will show TIMER ON/OFF which indicates you have chosen to set both the
starting time and off time.
FAN SPEED Indicator: Press the FAN SPEED button to select the desired fan speed
setting (Auto-Low-Med-High). You selection will be displayed in the LCD Window
except the Auto fan speed.
NOTE
NOTE
All signs shown in the Fig.2, is for the purpose of clear presentation. But during the
actual operation only the relative functional signs are shown on the display panel.
When replacing batteries, do not use old batteries or a different type battery. This
may cause the remote control to malfunction.
If you do not use the remote control for several weeks remove the batteries.
Otherwise battery leakage may damage the remote control.
The average battery life under normal use is about 6 months.
Replace the batteries when there is no answering beep from the indoor unit or if the
Transmission Indicator light fails to light.
Do not dispose batteries as unsorted municipal waste. Collection of such waste
separately for special treatment is necessary.
OPERATING THE REMOTE CONTROL
INSTALL/REPLACE BATTERIES
The Remote Control uses two alkaline dry batteries (LR03X2).
To install the batteries, slide the back cover of the battery compartment and install
the batteries according the direction (+and -) shown on the Remote Control.
To replace the old batteries, use the same method as mentioned above.
1
1
2
3
4
5
2
4
5
6
7