Ecox EPTL Owner's Manual - page 11
11
REMOTE CONTROLLER
SPLIT AIR CONDITIONER
EPTL
To set the Auto-on time.
Press the TIMER ON button. The remote control shows
TIMER ON, the last Auto-on setting time and the signal 'h"
will be shown on the LCD display area. Now it is ready to
reset the Auto-on time to START the operation.
Push the TIMER ON button again to set desired Auto-on
lime. Each time you press the button, the lime increases
by half an hour between 0 and 10 hours and by one hour
between 10 and
24 hours.
After setting the TIMER ON, there will be a one half second
delay before the remote control transmits the signal to
the air conditioner. Then, after approximately another
2 seconds. The signal “h” will disappear and the set
temperature will re-appear on the LCD display Window.
To set the Auto-on time.
Press the TIMER OFF button. The remote control shows
TIMER OFF, the last Auto-off setting time and the signal
"h' will be shown on the LCD d splay area. Now it is ready
to reset the Auto-off time to START the operation.
Push the TIMER OFF button again to set desired Auto-off
tune. Each time you press the button, the time increases
by half an hour between 0 and 10 hours and by one hour
between 10 and
24 hours.
After setting the TIMER OFF, there will be a one half
second delay before the remote control transmits the
signal to the air conditioner. Then. after approximately
another 2 seconds, the signal “h” will disappear and
the set temperature will re-appear on the LCD display
window.
1
1
2
2
3
3
3
1
The effective operation time set by the remote control for the timer function is limited to
the following setting: 0.5, 1.0, 1.5, 2.0, 2.5, 3.0, 3.5, 4.0, 4.5, 5.0, 5.5, 6.0, 6.5, 7.0, 7.5, 8.0,
8.5, 9.0, 9.5, 10, 11, 12, 13,14, 15, 16, 17, 18, 19, 20, 21, 22, 23 and 24.
CAUTIONS