Ecox EPTL Owner's Manual - page 6

6

REMOTE CONTROLLER

SPLIT AIR CONDITIONER

EPTL

6

7

8

9

10

11

4

5

Heat mode is for cooling & heating models only.

DIRECTION/SWING Button: Press this button once and quickly to change the air 

flow direction of the horizontal louver a little. The moving angle of the louver is 6º 

for each press. Press the button without releasing for 2 more seconds, the horizontal 

louver would swing automatically. Press it again, it would stop moving. When the 

louver swing/moving at a certain position which would automatically change the 

swing diretion (upward or down).

CLEAN AIR Button (on Some models): When push this button, the Ionizer or 

Plasma Dust Collector (depending on models) is energized and will help to remove 

pollen and impurities from the air.

SELF CLEAN (AUTO CLEAN) Button: Press this button under COOL or DRY mode, 

the self clean function is activated. Press it again will stop the operation and turn 

off the unit.

FOLLOW ME Button (on some models): Push this button to initiate the Folow 

Me, the remote control will send thisa signal to the air conditioner every 3 minutes 

interval until press the folow me button again. The air conditioner will beep to 

indicate the Folow Me feature has ended if it does not receive the signal during any 

7 minutes interval.

RESET Button: When you press the recessed RESET button, all current settings are 

cancelled and the control will return to the initial settings.

ON/OFF Button: Press this button to start the indoor unit. Press again to stop the unit.

FAN SPEED Button: Press the button to select the Fan Speed in the sequence: 

AUTO, LOW, MED and HIGH. Each time the button is pressed, the fan speed selection 

is shifted.

TIMER ON Button: Press this button to initiate the auto-on time sequence. Each 

press will increase the auto-timed setting in 30 minutes increments. When the 

setting time displays 10 h, each press will increase the auto-timed setting 60 

minutes increments. To cancel the auto-timed program, simply adjust the auto-on 

time to 0.0.

SLEEP Button: Press this button to go into the Energy-Saving operation mode. 

Press it again to cancel. This function is only can be used on COOL, HEAT and AUTO 

mode and maintain the most comfortable temperature for you.

12

While the unit is running under SLEEP mode, it would be cancelled if ON/OFF, FAN SPEED, 

SLEEP or MODE button is pressed

NOTE

NOTE