ECS P5GX-M User Manual - page 9
9
Make the Optional Internal Connections
1. Install any expansion cards into the expansion slots. The system has two 32-bit
PCI slots (PCI1, 2) and two 8/16-bit ISA slots (ISA1, 2).
2. If you have installed an internal fax/modem, cable the fax/modem to the modem
wake up connector J11. This will allow the system to wake up from a power
saving mode when an incoming call is detected.
3. If you have installed an internal network adapter, cable the adapter to the LAN
wake up connector J10. This will allow the system to wake up from a power
saving mode when incoming network traffic is detected.
4. If you have installed a CD-ROM drive, connect the audio-out cable from the CD-
ROM drive to the CD-Audio connector J15 on the mainboard.
5. If you are installing an optional infrared port, connect the cable from the infrared
port to the mainboard infrared connector, J17 (SIR-Serial Infrared).
6. If you are installing an optional second serial port, connect the cable from the
second serial port to the mainboard serial port connector COM2.
Note: If you install an infrared port, it must share a COM port assignment with
the second external serial port COM2. If you have installed a second serial
port and an infrared port, select which port is in use by using the setup utility.
7. If your system case has a chassis-mounted cooling fan, connect the cable from the
fan to one of mainboard cooling fan power supplies J1 or J4.