Ectaco Partner EF400T Deluxe User Manual - page 18
ECTACO Partner
®
EF400T User's
Manual
18
Software
y
Insert the supplied CD into the CD-ROM drive of a PC. If the installation
program does not start automatically, run the INSTALL.exe file from the CD
root catalog.
y
Choose EF400T PC-Link from the menu displayed on the PC.
y
After the program is installed, start it from Start/Programs/Ectaco. The
icon will appear in the System Tray.
9
The latest version of the PC-Link software and additional dictionaries can be
downloaded from Ectaco's web site at www.ectaco.com.
Sending and Rec eiv ing
y
Connect the PC-Link cable to the PC-Link jack located on the right-hand
edge of the device.
y
Press SHIFT+PC-LINK to enter the PC communication section.
y
Right-click the PC-Link icon in the System Tray. In the PC-Link program,
select an appropriate data transfer mode.
9
Make sure to select an appropriate COM port.
9
Make sure you have no other PC-Link program running simultaneously with
EF400T PC-Link.
y
Select the Send data transfer mode.Press ENTER.
y
Choose the section(s) you wish to send. Use SPACE to check or uncheck a
section.
y
Press ENTER to start the transfer.
9
Start the data transfer first on the receiving device, then on the sending
device.
y
To receive data, select the Receive data transfer mode. Press ENTER, and
the transfer will begin.
9
The time span between the data transfer startup on the PC and the device
must not exceed 30 sec.
9
Note that in the Receive data mode, the newly transferred data will replace
the old information saved in the corresponding sections of your device. In
case if empty sections are transferred, all data in the corresponding sections
of the EF400T will be erased.