Instruction manual bedienungsanleitung manuel d’utilisation manuale di istruzioni 1:10-scale 2wd monster truck kit congratulations on your purchase of the ecx ® amp ™ mt 2wd monster truck kit. This 1:10-scale model introduces you to the sport of rc driving. Herzlichen glückwunsch zum kauf des ecx am...
2 en notice all instructions, warranties and other collateral documents are subject to change at the sole discretion of horizon hobby, llc. For up-to-date product literature, visit http://www.Horizonhobby.Com and click on the support tab for this product. As the user of this product, you are solely ...
3 en water-resistant vehicle with waterproof electronics your new horizon hobby vehicle has been designed and built with a combination of waterproof and water-resistant components to allow you to operate the product in many “wet conditions,” including puddles, creeks, wet grass, snow and even rain. ...
4 en warning: failure to exercise caution while using this product and comply with the following warnings could result in product malfunction, electrical issues, excessive heat, fire, and ultimately injury and property damage. • never leave charging batteries unattended. • never charge batteries ove...
5 en step 2: assemble the amp monster truck thank you for purchasing the amp monster truck kit. The kit includes 6 bags marked a–f. Each bag contains secondary bags labelled with assembly step numbers. The kit contains the correct number of parts to build the amp monster truck. Open the "tools" bag ...
70 en step 3: paint and sticker the amp monster truck body shell 1. Clean the inside of the amp mt body shell using a small amount of water and dish soap. Thoroughly rinse and dry the body shell with a cloth towel. Tip: do not use paper towels. 2. Paint the inside of the amp mt body shell. 3. Once t...
71 en caution: if using rechargeable batteries, charge only rechargeable batteries. Charging non-rechargeable batteries may cause the batteries to burst, resulting in injury to persons and/or damage to property. 1. Remove the battery cover from the transmitter. 2. Install four aa batteries as shown....
72 en electronic speed control (esc) connecting 1. Connect the red (+) esc wire to the red (+) motor wire. 2. Connect the black (–) esc wire to the black (–) motor wire. Notice: always disconnect the battery from the esc when you have finished operating your vehicle. The esc switch only controls pow...
73 en problem possible cause solution short run time • battery damaged/not charged • motor dirty • check/change battery • check/clean sluggish action • motor dirty • bind in drivetrain • vehicle battery is not charged • check/clean • clean/adjust • replace/recharge controls reversed • st. Rev or th....
74 en what this warranty covers horizon hobby, llc, (horizon) warrants to the original purchaser that the product purchased (the “product”) will be free from defects in materials and workmanship at the date of purchase. What is not covered this warranty is not transferable and does not cover (i) cos...
75 en fcc statement this device complies with part 15 of the fcc rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Caut...
Ecx03034 www.Ecxrc.Com © 2016 horizon hobby, llc. Ecx, the ecx logo, amp, ec3, dynamite, speedpack and the horizon hobby logo are trademarks or registered trademarks of horizon hobby, llc. Created 01/2016 48613.
