ECX AMP mt ECX03034 Instruction Manual - page 6
70
EN
STEP 3: PAINT AND STICKER THE AMP MONSTER TRUCK BODY SHELL
1. Clean the inside of the AMP MT body shell using a small amount of
water and dish soap. Thoroughly rinse and dry the body shell with a
cloth towel.
Tip: Do not use paper towels.
2. Paint the inside of the AMP MT body shell.
3. Once the paint is completely dry, remove the over-spray film from the
outside of the body.
4. Using the chart below, apply the windows, grill, head lights, and tail
lights. Apply additional stickers to customize the AMP MT body.
STEP 4: INSTALL THE VEHICLE BATTERY
When the battery is charged, install it into the AMP MT chassis.
1. Plug the blue EC3™ battery connector into the blue EC3 ESC
connector. They will only plug together in one direction.
2. Install the body shell and secure it with the four body clips.
1
2
3
4
5
6
7
8
9
10
8
6
7
10
9
1
2
3
4
5