ECX BARRAGE Instruction Manual

Manual is about: 1:12 GEN2 4WD 1.55 BRUSHED SCALER RTR

Summary of BARRAGE

  • Page 1

    Congratulations on your purchase of the ecx ® barrage ® gen2 4wd 1.55 brushed scaler. This model introduces you to the sport of rc driving. Herzlichen glückwunsch zum kauf des ecx barrage gen2 4wd 1.55 brushed scaler. Dieses modell ist der gelungende einstieg in die welt des rc cars sports. Nous vou...

  • Page 2

    2 en water-resistant vehicle with waterproof electronics your new horizon hobby vehicle has been designed and built with a combination of waterproof and water-resistant components to allow you to operate the product in many “wet conditions,” including puddles, creeks, wet grass, snow and even rain. ...

  • Page 3

    3 en 1:12 gen2 4wd 1.55 brushed scaler rtr quick start....................................................................................................3 vehicle preparations ....................................................................................4 charging the vehicle battery ...........

  • Page 4

    4 en installing the battery 1. Remove the vehicle body. 2. Install a fully charged battery. 3. Secure the battery pack using the hook and loop straps. 4. Connect the battery pack to the esc power connector. Caution: connecting the battery to the esc with reversed polarity will cause damage to the es...

  • Page 5

    5 en 1:12 gen2 4wd 1.55 brushed scaler rtr this transmitter requires 4 aa batteries. 1. Remove the battery cover from the transmitter. 2. Install the batteries as shown. 3. Install the battery cover. Caution: if using rechargeable batteries, charge only rechargeable batteries. Charging non-rechargea...

  • Page 6

    6 en 1. Power on the transmitter. 3. Perform a test of the transmitter’s control of the vehicle with the vehicle’s wheels off the ground. 4. Start driving slowly, and, if the vehicle does not go straight, adjust the steering trim dial on the transmitter. Important: seat the motor brushes by driving ...

  • Page 7

    7 en 1:12 gen2 4wd 1.55 brushed scaler rtr • always turn on your transmitter before you turn on the receiver in the vehicle. Always power off the receiver before turning your transmitter off. • always operate your vehicle in a wide open area. Operating the vehicle in a small space or indoors can cau...

  • Page 8

    8 en maintenance setting the gear mesh the gear mesh has already been set at the factory. Setting the gear mesh is only necessary when changing motors or gears. You must remove the vehicle’s gear cover (a) to make this adjustment. Proper gear mesh (how the gear teeth meet) is important to the perfor...

  • Page 9

    9 en 1:12 gen2 4wd 1.55 brushed scaler rtr troubleshooting guide problem possible cause solution short run time battery damaged/not charged check/change battery motor dirty check/clean sluggish action motor dirty check/clean bind in drivetrain clean/adjust vehicle battery is not charged replace/rech...

  • Page 10

    10 en limited warranty what this warranty covers horizon hobby, llc, (horizon) warrants to the original purchaser that the product purchased (the “product”) will be free from defects in materials and workmanship at the date of purchase. What is not covered this warranty is not transferable and does ...

  • Page 11

    11 en 1:12 gen2 4wd 1.55 brushed scaler rtr fcc id: xnzecx13008 this equipment has been tested and found to comply with the limits for part 15 of the fcc rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment gener...

  • Page 12

    40 replacement parts / ersatzteile / pièces de rechange / pezzi di ricambio part # description beschreibung description descrizione dyn1462 7.2v 900mah nimh battery ec3 7.2v 1200mah ni-mh akku, ec3 batterie ni-mh 7.2v 1200ma, prise ec3 batteria 7.2v 1200mah ni-mh, ec3 dyns1206 390 motor, 22t pinion ...

  • Page 13

    41 1:12 gen2 4wd 1.55 brushed scaler rtr optional parts / optionale teile / liste des options / elenco parti opzionali part # description beschreibung description descrizione dyn1471 7.2v 1750mah nimh 6c flat battery, ec3: minis flache akkus ni-mh 7,2v 1750ma, ec3: mini 1/18 mini 1/18: batterie plat...

  • Page 16: Www.Ecxrc.Com

    Www.Ecxrc.Com ecx01013t1/t2 ® © 2018 horizon hobby, llc. Ecx, the ecx logo, barrage, dynamite, speedpack, prophet, tazer, ec3, and the horizon hobby logo are trademarks or registered trademarks of horizon hobby, llc. The spektrum trademark is used with permission of bachmann industries, inc. Updated...