ECX ECX8400 Instruction Manual - page 7
7
EN
• ALWAYS turn on your transmitter before you turn on the
receiver in the vehicle. Always turn off the receiver before
turning your transmitter off.
• ALWAYS operate your vehicle in a wide open area. Operating the
vehicle in a small space or indoors can cause overheating at low
speeds. Operating at low speed increases heat in the electronic
speed control (ESC). Overheating can damage the vehicle and
failure may result.
Steering dual Rate
• If the vehicle turns too sharply and/or spins out easily, reduce
the steering dual rate (turn the knob counterclockwise).
• For sharper or additional steering, increase the steering dual rate
(turn the knob clockwise).
Throttle Operation
• Pull the transmitter trigger to increase throttle.
• Push the trigger to apply brake or reverse.
IMPORTANT: The slower the vehicle is moving, the quicker it will
change from forward to reverse.
1. Power off the vehicle.
3. Disconnect the battery box from the ESC/Receiver unit.
4. Remove the battery box from the vehicle.
2. Power off the transmitter.
OPERATION
Off
WhEN yOU ARE fINIShEd