Eddie Bauer 10330 User Manual - page 3
3
To Assemble Basket
(continued)
2
Basket Board:
Locate Basket Board and position
with ten strips underneath. Line up
notches to bars and slide Basket
Board down (Figure 2).
Press plastic ends firmly onto
metal (Figure 2a).
Secure Basket Board to Metal Side
Rails with four screws (Figure 2a).
2a
3
Bedding:
Slip Bedding over Metal Frame Assembly and pull down
completely (Figure 3). Arrange holes in fabric opening over
plastic knobs and tuck fabric inside frame.
Lift ruffles on Bedding and loop six straps through slots in
basket board. Loop four end straps through slots in plastic
ends. Secure each strap to patch under Basket Board
(Figure 3a).
3
3a
Openings
1
Bottom Rail Assembly:
TIP: Assemble with Headboard placed on its side.
Locate holes in Headboard. Place two wooden dowels in
second holes from the bottom (Figure 1). Dowels should be
placed on same side as knobs.
Locate Bottom Rail Assembly and position (as shown) with
T-nut hole facing down (Figure 1). Slide end of Bottom Rail
Assembly onto wooden dowels.
Position T-nuts with cross facing down and hole facing so as to
receive bolt. Place T-nuts into holes and secure using two bolts
(Figure 1).
NOTE: Do not assemble other Headboard until Step 3.
1
Screw (4)
2
Notch
Bar
Strap
To Assemble Wood Frame
Knob Faces In
Bolt (2)
2
Rail:
Place two wooden dowels in top holes of Headboard
(Figure 2).
Locate Rails and slide hole without metal insert onto dowels
(Figure 2).
Position T-nuts with cross facing down and hole facing so as to
receive bolt. Place T-nuts into holes and secure using two bolts
(Figure 2).
Wood
Dowel (2)
Bolt (2)
2
Plastic Ends
Bottom Rail
Assembly
Rails
4
Pad and Sheet:
Slide Pad into opening of Sheet (Figure 4) and secure
together.
Place covered Pad into Basket.
4
Pad
Sheet
Wood
Dowel (2)
T-Nut
(2)
T-Nut Hole Faces Down
Inside
View
Inside
View
T-Nut
(2)