Eddie Bauer 10330 User Manual - page 4
3
Second Headboard:
Position Headboard with knob facing in. Repeat Steps 1 and 2 for
other Headboard (Figure 3).
3
4
4
Casters:
Locate two Casters with locks (Figure 4).
Locate four holes at bottom of Headboards. Push two
Casters with locks into the holes diagonally from one
another (Figure 4a).
Push remaining two Casters in the opposite holes. Stand
Wood Frame upright.
4
To Assemble Wood Frame
(continued)
Locks
4a
5
Storage Area:
Locate Storage Skirt and Storage Board. Slide Storage Board
into opening of Skirt (Figure 5).
Place covered Storage Board on Bottom Rail Assembly and
arrange ruffles of Skirt over Rails. Tie a bow around each
corner (Figure 5a).
5
Storage
Board
5a
6
Music Module:
Slide Music Module over plastic mount with battery door
toward outside (Figure 6).
Remove battery door, using a Phillips head screwdriver
(Figure 6a). NOTE: Do not replace battery door yet.
6
6a
Battery Door
8
8
Slide Locks:
Locate Slide Locks and orient with their concave sides facing
in. Tilt Slide Lock and pivot firmly onto the knob (Figure 8).
Repeat on other side.
Diagonally
7
7
Secure Music Module:
Secure Music Module with two Mounting screws, but do not
over tighten (Figure 7).
Music Module
Mounting Screw
(2)
Knobs Face In