Eddystone xa500 series Installation And Operaion Manual - page 3
Print Date 31/08/11 Page 3 of 22 E2136-00MA-02
Index
SECTION ONE : INTRODUCTION
1.1 : GENERAL DESCRIPTION………………………………………………………………… Page 5
1.1.1 Power Supply………………………………………………………………..……………… Page 5
1.1.2 Input Splitter..………………….……………………………………………………………. Page 5
1.1.3 Amplifier Modules (‘Pallets’)……………………………………………………………….. Page 5
1.1.4 Two Way Combiner, Low Pass Filters and Directional Coupler……………….……… Page 6
1.1.5 Control/Display Boards………………………………………………….……………..….. Page 6
1.1.6 Interface Board …………………………………………………………………………….. Page 6
1.1.7 Serial Remote Control and Monitoring Board (/A and /T options only)……………….. Page 7
1.2 : VARIANTS AND OPTIONS………………………………………………………………… Page 7
1.3 : TECHNICAL SPECIFICATIONS…………………………………………………………… Page 8
SECTION TWO : INSTALLATION
2.1 : PHYSICAL DIMENSIONS AND FITTING………………………………………………… Page 11
2.1.1 Installation Accessories……………………………………………………………………. Page 11
2.1.2 Rack Mounting………………………………………………………………………………. Page 12
2.2 : EXTERNAL CONECTIONS…………………………………………………….………….. Page 12
2.2.1 Mains Supply Connector.………………………………………………………………….. Page 12
2.2.2 Status Connector…………………………….……………………….……………………. Page 13
2.2.3 RF Output Antenna Connector…………………………………………………………….. Page 14
2.2.4 RF Input Connector……………………………………………..………………………….. Page 14
2.2.5 RF Output Monitor Connector……………………………………………………………... Page 14
2.2.6 REMOTE (COM) Port Connector (/A option only) ……...………………………….…… Page 14
2.2.7 REMOTE (TCP/IP) Connector (/T option only)…………..……………………………... Page 15
2.3 : SETTING UP PROCEDURES………………….………………………………………….. Page 15
2.3.1 Fuses…………………………………………………………………………………………. Page 15
2.3.2 Output Power Level and Frequency Adjustment………………………………………… Page 16
2.4 : SERIAL REMOTE CONTROL AND MONITORING (/A and /T options only)……….… Page17
2.4.1 Introduction ………………………………………………………………………………….. Page 17
2.4.2 Control Commands and Status Monitor Requests …………………………………..…. Page 17
2.4.3 Reverted Status Monitor Information …………………………………………………….. Page 18
SECTION THREE : OPERATION
3.1 : CONTROLS AND DISPLAYS…………………..…………………………………..……… Page 21
3.1.1 Front Panel…………….……………………………………………………………………. Page 21
3.1.2 E2322 Power Supply Units…………………….………………………………………….. Page 22