Eden HA2000 Installation & Operating Manual - 8. Exit Sound
PROBLEM?
10
Do not HESITATE to call us via our assistance hotline (at the end of the notice). Our technicians will have the pleasure to
help you make a perfect installation.
This is for you to decide whether to enable or
disable the Control Panel Tamper protection.
C . U . T a m p e r O n
C . U . T a m p e r O f f
z
Press “S”,” T” keys to select the option.
z
Press
“OK”
to confirm.
z
“C.U. Tamper Off” is set as factory default.
N
N
O
O
T
T
E
E
>
>
)
Remember to enable the Tamper
protection after all the programming and
installations are completed.
8. Exit Sound
This is for you to select between high and low
audible volume for the warning beeps during the
Exit Delay period.
E x i t S o u n d L o w
E x i t S o u n d H i g h
z
Press “S”,” T” keys to select the option.
z
Press “OK” to confirm
z
“Exit Sound Low” is set as factory default.
9. Entry Sound
This is for you to select between high and low
audible volume for the warning beeps during the
Entry Delay period.
E n t r y S o u n d L o w
E n t r y S o u n d H i g h
z
Press “S”,” T” keys to select the option.
z
Press
“OK”
to confirm.
z
“Entry Sound Low” is set as factory default.
10. Door Chime
This is for you to turn on and off the door chime in
the Control panel and select the volume between
high and low volume.
C h i m e L o w
C h i m e H i g h
C h i m e O f f
z
Press “S”,” T” keys to select the option.
z
Press “OK” to confirm
z
“Chime Low” is set as factory default.
N
N
O
O
T
T
E
E
>
>
)
If “Chime Low” or “Chime High” is
selected, when an “Entry” Door Contact
or PIR is triggered while the system is in
Disarmed mode, the Control Panel will
sound the Door Chime.
11.Interference
This is for you to switch on/off the interference
detection function.
z
When the interference detection is switched
on, interference will be detected if it is
present for 30 seconds or longer.
z
When the interference detection is switched
off, the Control Panel will not respond at all to
interference.
I n t . D e t e c t O n
I n t . D e t e c t O f f
z
Press “S”,” T” keys to select the option.
z
Press
“OK”
to confirm
z
“Int. Detect Off” is set as factory default.
N
N
O
O
T
T
E
E
>
>
)
“Int. Detect On”
will enable the Control
Panel to treat interference as a fault
when in Disarmed mode or Home mode.
When Away armed, the Control Panel will
produce a full alarm once only.
12. Warning Beep
This is for you to turn on and off the system fault
warning beep. The Warning Beep is a periodic
warning tone given by the Control Panel to draw
user’s attention in the event of a system fault
being active.
W a r n i n g B e e p O n
W
a r n i n g B e e p O f f
z
Press “S”,” T” keys to select the option.
z
Press “OK” to confirm
z
“Warning Beep On” is set as factory default.
N
N
O
O
T
T
E
E
>
>
)
If “Warning Beep On” is set, when the
system is in Disarmed mode, the Control
Panel will sound a short beep every 30