Eden HA2000 Installation & Operating Manual - 2. Door Chime
the Remote Keypad or Remote
Controller.
2. Door Chime
If an “Entry” Door Contact or PIR Detector is
triggered, the Control Panel will sound a ding-dong
door chime, (if Door Chime function is enabled)
IV. Home mode
The Home mode allows the home to be Armed so that
no one can get inside without first disarming the
system, yet the person already inside the house can
move freely without self triggering the alarm.
1. Entering the Home mode
To put the system into the HOME mode:
Step 1.
Enter your PIN code and press “OK”
within 10 seconds. The display will
show:
PROBLEM?
9
Do not HESITATE to call us via our assistance hotline (at the end of the notice). Our technicians will have the pleasure to
help you make a perfect installation.
A w a y
A r m
H o m e A r m
W
a l k T e s t
L o g
and the cursor stays at “ Away Arm”
Step 2.
Press “T “ to move the cursor down to
select “Home Arm”.
Step 3.
Press “OK”
Step 4.
The following screen will be displayed.
T i m e t o E x i t
1 0 s e c
The counting down Exit Delay is
displayed on the left side of the 2nd line
in silence.
N
N
O
O
T
T
E
E
>
>
)
The screen will go blank after 10 sec. but
the counting down countinues. Pressing
“OK”
will pop the display up for another
10 sec..
Step 5.
When the Exit Delay time is up, the
Control Panel will sound three short
beeps. The system is in Home Arm
Mode and the LCD display stays blank.
N
N
O
O
T
T
E
E
>
>
)
You can also put the system into the
Home mode by pressing the “Home”
button on the Remote Controller and the
Remote Keypad, however, there will be
no Exit Delay by this command.
2. Stopping the Exit Delay
The Exit Delay can be stopped by disarming the
system.
Step 1. Press “
“
Step 2.
The screen will ask you to enter the PIN
code. In addition, the counting down Exit
Delay is displayed on the left side of the
2
nd
line.
Step 3.
Enter your PIN code and thenpress
“OK”. “Alarm off”
will be displayed on
the screen and the system returns to
Disarmed mode.
N
N
O
O
T
T
E
E
>
>
)
The Exit Delay can also be stopped by
pressing the “
”
button on the Remote
Controller.
)
If the Exit Delay period times out before
the code can be entered, the system will
arm.
3. Extend the Exit Delay
During the Exit Delay period, the delay time can be
extended by pressing the “
” button on the Remote
Controller and the Remote Keypad. Each time the
“
” button is pressed, the delay time starts counting
from the beginning.
V. Alarm Activation
1. Away Arm Mode
z
If any of the sensors are triggered, the Control
Panel will activate the alarm.
z
If an “Entry” Door Contact or PIR Detector is
triggered, the alarm will sound providing the Entry
Delay has expired.
z
If other sensors are triggered, the alarm will be
activated immediately.