Emhart AutoSet 5 Operator's Maintenance Manual - page 6
Packaged Accessories
Part No.
Item
Qty
Part No.
Item
Qty
DP220-155
Oil Fill Bottle (empty)
1
DP220-070 Pipe
Spanner
1
DP220-074 Screwdriver
1
DP220-071 T-Wrench
1
DP220-165 Maintenance
Tube
1
DP220-623
Jaw Setting Jig (2-pc)
1
DP220-073
14mm Flat Wrench
1
DP220-154
2.5mm Hex Key
1
DP220-072
15mm Flat Wrench
1
DP220-153
5mm Hex Key
1
DP220-502
5-size Nosepiece (AutoSet
®
5 only)
1
P444 Maintenance
Manual
1
DP220-636
Air Hose Assembly
1
FG2177 Warranty
Card
1
DP220-075
Training Nose Adaptor*
1
* Note: An optional Training Nose Adaptor is shipped with the
AutoSet
®
tool (Fig. 2). The Training Nose Adaptor may be
installed to prevent accidental tool and/or application damage
due to the cycling motion of the Nose Piston until the
operator becomes familiar with the tool operation.
! When the Training Nose Adapter is installed, a
pinch point is created between the Nose Piston
and Training Nose Adapter !
TRAINING NOSE ADAPTER
ATTACHMENT SCREWS
W
Figure 2: Training Nose Adapter
Tool Requirements
Air Supply* . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 85-100 PSI (5.8-6.9 Bar) filtered, lubricated
Air Flow . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 scfm (150 l/min) Minimum
Hydraulic Oil** . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Shell Spindle Oil #22 or Emhart equivalent
Jaw Lubricant**. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Lithium Grease w/ Molybdenum Disulfide
Seal Lubricant**. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Shell Spindle Oil #22 or Emhart equivalent
(See the Safety Data section for Emhart equivalents.)
* Note: It is recommended that a combination
Filter/Regulator/Lubricator (DP220-804) be installed in the air
supply to the tool (Fig. 3). If an Inline Lubricator is not
installed, then tool lubrication must be performed as indicated
in the “Maintenance” section.
** Note: Lubricant Safety information is located in the “Safety
Data” section.
LUBRICATOR
FILTER
REGULATOR
AIR SUPPLY
Figure 3: In-line Lubrication set-up.
Page 6
Emhart Teknologies - 50 Shelton Technology Center, Shelton CT 06484 - Tel. (203) 924-9341 - Fax (800) 225-5614