Emo-bike Feddz User Manual - page 6
6
To charge the battery you need a normal 230V-oulet
having a 16A-fuse or circuit breaker. First, connect
the DC-plug on the bike, then the plug into the elec-
tric outlet.
The DC-plug of the charger is magnetically and po-
larity secured, i.e. it finds the correct position when
turned in the connector until the right position is
reached. Please pay attention that the DC-plug is
clean. Even a little bit of dirt can prevent a good con-
nection, so that the battery will not charge correctly.
The switch on the battery charger should be turned
on only when both ends have been properly con-
nected. The charger then shows that it is working
properly by the alternating blinking of its lamp dio-
des. As soon as the charging has been successfully
initiated, the lamp “charging” will stay on and, de-
pending on the amount of charging necessary, this
can last several hours. The charger will turn off au-
tomatically, such that the battery cannot be over-
charged.
After charging, the LED Lamp „full“ is turned on in-
dicating that the battery is fully charged and ready
for use. The amount of charge in the battery can be
checked using the main display. Should a red lamp
indicating “error” turn on, please contact us imme-
diately.
Caution: Danger to life through
electric shock!
Never open the charger, and
only allow a professional to
service the unit!
Battery charging and mounting