Emotiva BasX A-800 User Manual - X A-800 Front Panel

Page 7

B

AS

X  A-800 Multi-Zone Power Amplifier

B

AS

X A-800 Front Panel

A-800

1

2

 1. Standby Button

Note: The BaxX A-800 amplifier will only operate when the rear panel AC Power Switch is in the 

On position.

Press the Standby Button to turn the amplifier On; press again to return to Standby; the halo ring 

around the button illuminates amber for Standby and blue for On. 

Note: If the BasX A-800 is in Standby Mode, then pressing the Standby Button will turn it On. If 

the BasX A-800 is On, then pressing the Standby Button will return it to Standby Mode. Please 

see the BasX A-800 Power Mode Switch section for details about the various options available 

on the BasX A-800.

 2. Status Display Window

This window houses the status LEDs.

Note: The Status LEDs can be disabled by the Status LEDs switch on the rear panel.

Note: In Standby mode the halo ring on the Standby button will be illuminated amber and 

the Status LEDs are not lit; in normal operation the Status LEDs and Standby Button are both 

illuminated blue. If a fault occurs, the amplifier output will shut off, all eight Status LEDs will 

flash red, and the halo on the Standby Button will flash amber. (If this occurs, press the Standby 

Button once to place the A-800 into Standby and reset the fault. Then, after removing the fault, 

you may press the Standby Button again to turn the amplifier back On. The fault may also be 

reset by turning the rear panel AC Power Switch Off and On again.)