Emotiva XSP-1 User Manual - Trigger and Ir:
Page 25
XSP-1
Phono Section (moving coil, phono in to balanced out):
Gain (1 kHz, Volume set to “0”): approximately 60 dB.
Input impedance (user selectable): 47 ohms, 100 ohms, 470 ohms, 1k ohm.
S/N (signal-to-noise ratio, A-weighted, ref 1.0 mV in): > 79 dB.
Frequency response (referenced to standard RIAA curve): 20 Hz to 20 kHz +/- 0.35 dB.
THD (total harmonic distortion, ref 1.0 mV):
IMD (intermodulation distortion, SMPTE method:
Crosstalk:
Phono Section (moving magnet, phono in to balanced out):
Gain (1 kHz, Volume at 0): approximately 40 dB.
Input impedance: 47k Ohms.
S/N (signal-to-noise ratio, A-weighted, ref 10.0 mV in, A-weighted): > 96 dB.
Frequency response (referenced to standard RIAA curve): 20 Hz to 20 kHz +/- 0.3 dB.
THD (total harmonic distortion, ref 10 mV):
IMD (intermodulation distortion, SMPTE method:
Crosstalk:
Trigger and IR:
Trigger Input; Trigger Output.
IR input; IR Output.
Front Panel Controls and Indicators:
Volume; rotary knob (digital encoder).
Standby; push button; halo lighting changes color to indicate Standby or On).
Input Selector; push buttons (7); with halo lighting.
Mute; push button.
HT Bypass; push button.
Processor Loop; push button.
Dim; push button.
High Frequency and Low Frequency Trim Controls (4); push buttons.
Direct; push button (bypasses High Frequency and Low Frequency Trim controls).
Halo light around Standby push button (illuminates yellow for Standby and blue for On).
Rear Panel Controls:
AC Power switch; rocker switch (switches AC mains power).
Moving Coil / Moving Magnet Cartridge Selector; slide switch.
MC Impedance Selector; slide switch.
High Pass / Full Range, Low Pass / Full Range); toggle switches (2).
High Pass Crossover Point, Low Pass Crossover Point; adjustment trimpot (2).