EYEZONE OP191080P-1 User Manual - page 4
5
Use the screws to fasten the brackets to the screw holes as shown below.
If you want control or set up the OP191080P by remote control, the
IR Cable
or
PIR Sensor
(receive the signal of remote control) must be connected first.
7. CONNECT THE IR CABLE/ PIR SENSOR
6. ATTACHING BRACKETS
6
Power On
z
Insert the CF memory card that has Picture, Music, Movie or WMV9 files.
z
Press the “POWER” button on the remote control to power on the Eyezone OP191080P.
(confirm the power switch on the left side is turned on first)
Status After Power On
z
Status 1
:
If the “AUTOPLAY (Movie or Picture)” function is enabled and there are movie
or picture files in the CF card, the Eyezone OP191080P will auto play movie or picture
files on the CF card after power on.
z
Status 2
:
If the “AUTOPLAY” function is disabled, after power on the main menu will
appear as shown in the following figure. There are two groups in the main menu
(“/mnt/CF” and “SETUP”).
NOTE
:
The pop-up window that shows the IP address will appear later, if DHCP mode is selected
when the Eyezone OP191080P is turned on.
Power Off
:
Press the “POWER” button again to power off.
8. START THE OP191080P