EZCast 5G Quick Start Manual - page 7
Please launch the “EZChannel” App on your device,
and you may see the “search” button on top-right
corner, enter your favor keyword for searching. Go to
the “Personal” page to create your personal channel,
and then you could use the “+ add” button for
adding video to your personal channel. Please use
the “cast” button on bottom-left corner for binding
with an EZCast dongle, and you could see the status
of “cast” button will be changed after binding.
Settings and Firmware Upgrade
Please use the “EZCast” App on your device to setup
your EZCast dongle as below
(1) Resolution: Change the output resolution
(2) Internet: Change the WiFi AP connection setting
(3) Default Mode: Change the power up mode
(3.a) EZCast mode: EZCast dongle control by EZCast app
(3.b) EZMirror + Timer: EZCast will stay at EZMirror(Miracast) mode,
and then switch to EZCast mode 120 seconds after dongle boot up.
(3.c) EZMirror + AP ~ EZCast will support both EZMirror (Miracast)
and EZCast mode all the time.
(4) Connection: Change the network connection
(4.a) Direct Link Only: Allow only “direct link” connection
(4.b) Via Router Allowed: Allow both “direct link” and “router”
connection
(4.c) Via Router Only: Allow only “router” connection