EZPull MTX-8 User Manual - Automatic Power Down
EZP_MTX8_UserGuide.doc
For Version 1.1.0
E
E
Z
Z
P
P
u
u
l
l
l
l
M
M
T
T
X
X
-
-
8
8
U
U
s
s
e
e
r
r
M
M
a
a
n
n
u
u
a
a
l
l
Page 2
Turn EZPull MTX-8 On
When the EZPull MTX-8 is turned off, the display is blank.
Press the ON/OFF key [ ]. The Main menu will display on the LCD.
Turn EZPull MTX-8 Off
From the Main menu, press the ON/OFF key [ ].
Using the MTX-8 in Manual Mode
1. From the Main menu, press the [1-A] key. The display will show:
2. To release a single target, press and release any of the keys 1 to 8.
The Red LED will glow and the target released will be displayed
for about 2 seconds.
3. To throw a True-Pair using two hands: Simultaneously press any two keys 1 to 8.
The Red LED will glow and the targets released will be displayed for about 2 seconds.
4. To throw a True-Pair using one hand:
4.1.
Press the Fire [
] key. The display will show “TP ?” indicating that you should select
the two traps.
4.2.
Select the first trap using any of the keys 1 to 8. For trap #1, the display will show
“TP 1” indicating that the first trap was selected.
4.3.
Select the second trap using any of the keys 1 to 8.
Do not select the same trap number used to select the 1
st
trap!
For trap #2, the display will show “TP 1 + 2” indicating
both traps are selected.
4.4.
When the shooter is ready, press the Fire [
] key again
to throw the pair.
4.5.
Notes:
4.5.1. If you selected only one target, you can abort the pair by pressing the Fire [
]
key
4.5.2. Once a pair is selected it is not possible to throw a single until the pair is released.
4.5.3. Once a pair is selected, as long as you did not press the Fire [
] key, you can
change the selection by pressing any other keys 1-8.
5. Exit manual mode by pressing the [ ] key.
Automatic Power Down
After a preset idle time (typically, 5 to 15 minutes) with no key presses, the MTX-8 will go into
low power mode and the display will go blank. If this occurs during target release, (manual or
automatic modes), press the ON/OFF key [ ] to return to the last activity prior to power down.
Low Battery
When the batteries are nearly empty, the display will show
the “empty battery” icon. Replace the batteries.
1.MANUAL 2.AUTO
3. SETUP
. OFF
MANUAL MODE
.PAIR
. EXIT