EZPull MTX-8 User Manual - 3>4
EZP_MTX8_UserGuide.doc
For Version 1.1.0
E
E
Z
Z
P
P
u
u
l
l
l
l
M
M
T
T
X
X
-
-
8
8
U
U
s
s
e
e
r
r
M
M
a
a
n
n
u
u
a
a
l
l
Page 3
Using the MTX-8 in Auto Sequence Mode
In Auto Sequence mode the 5-Stand target menu is preselected
by the club’s personnel.
1. From the Main menu, press the [2-B] key. The display will show
the number of shooters selection screen.
2. Use the ▲[3-C] and ▼ [8-H] keys to select the number of shooters
then press the Enter [
] key to accept and continue.
Notice: The first shooter must always start on the first stand with
the other shooters following the order of stands – no skipping stands!
3. Press the Enter [
] key to start the game. The display will
momentarily show the key functions used in this mode.
4. The Display will now show the first target in the sequence.
On the left side you will see the Stand number - STD:# and the
Queue number - QUE:# number (In 5-Stand, all shooters shoot
the first queue, then the second queue, etc.)
5. Fire: Press the Fire [
] key to release the target(s). The display will
now show the next target(s) to be released.
6. Back: If targets are broken or you need to repeat a segment in the sequence, press the
◄
[4-D] key to go back. Note the STD:# and QUE:# to navigate back to the desired
segment.
7. Skip: If you need to skip a segment in the sequence, press the ► [5-E] key to skip to the
next segment. Note the STD:# and QUE:# to navigate to the desired segment.
8. Manual: If you need to momentarily switch to a fully manual mode, press the ▲ [3-C] key.
The MTX-8 will operate in manual mode (see above). Press the [ ] key to return to
automatic sequence mode at the last segment where you left it.
9. Pairs: There are three release modes for pairs:
9.1.
True Pair: Press the Fire [
] key - Two targets
release simultaneously. Indicated by a “
+
” between
the trap numbers
9.2.
Report Pair: Press the Fire [
] key - First target released.
Red LED ON steady reminding you to act on report.
Press the fire [
] key again upon shooters
gunshot (report) to throw the second target and
advance to the next segment. Indicated by a “
>
” between
the trap numbers.
9.3.
Following Pair: Press the Fire [
] key - First target released.
Red LED blinks indicating you should wait the delay.
The second target releases automatically after the number
of seconds shown under the ~ symbol. Indicated by a “
~
”
between the trap numbers.
10. When the sequence is complete, the display shows “GAME OVER”.
Press the Enter [
] key to start over or the [ ] key to return to the main menu.
#SHOOTERS
▲▼
04
FIRE
▲ MANL
◄ BACK ►SKIP
STD: 1
QUE:1
2
STD: 2
QUE:2
3>4
STD: 2
QUE:3
3+4
STD: 3
QUE:2
3~4
4