Ezy Flame EZFG-18 Owner's Manual - Lighting Procedure

14

Operating your firegrate

Step 1

Step 2

Step 3

1.  To light the burner: 

  Open the damper plate   

  and  place the hooked end of  

  the damper control rod into the  

  fuel chamber and push the rod  

  down slightly into the fibre material  

  so that the rod  picks up a small  

  amount of fuel. 

2.  Withdraw the rod from the burner  

  and manually light the end of the  

  rod with a lighter. We do not  

  recommend directly lighting the  

  burner with a match as  it could  

  present a hazard while starting the  

  fire. 

3.  Place the lit end of the damper  

  rod into the burner chamber. The  

  fire will now light. If the burner fails  

  to light, repeat steps 1-3. 

A cold burner will normally start with a 

sudden rushing effect indicated by a 

small puff. This is normal and is not a 

matter of concern. 

When the burner is lit, ensure the 

damper rod flame is extinguished 

before placing the rod on a non 

combustble surface before storing 

the rod.

Lighting procedure

Prior to lighting your firegrate, ensure the burner is filled to the desired level. 

Close the burner damper control after filling.

Lighting your firegrate