F&V F1 User Manual - page 4
Connect relevant signals together and connect to power,then the unit will be in a
standby state(the red light for power is on).Press button,the red light will turn off,
which means the unit is go into working condition. If press the button again,this
unit change to standby state.State in the boot no signal input, the red power light
blinks,the screen appears "No Signal"message, if the menu "function " is set to open
in the blue screen, then a blue screen.
Operating Instructions
Remote controllerφ
Power ON/OFF
AV1/AV2/HDMI switch
Subject selection key,or to adjust the Contrast directly
Subject selection key,or to adjust the brightness directly
To activate OSD menu or select
Color/B&W switchχExit key on the set menu
Menu Operationφ
Press button ,you can enter relevant OSD menu operationθpress / on
the unit or on the remote controller to select the items:Color,Adjust,ODS,Function,
Sound,and confirm by pressing button.
Sound
1ȽColorφ
Press button to enter the menu, press the button again to confirm the
selection current Color mode, press the up or down compared with the option to
change the current mode, press the MENU button to confirm the current option,
press the up or down key was to change The current option settings.
Brightnessφ0—100
Contrastφ0—100
Saturationφ0—100
sharpnessφ0—100
Color Tempφ9300KȽ6500Ƚ3200K
Main menu
Icon
Submenu
Signal data
Color
Adjust
ODS
Function
Menu interface
-5-
-6-