FAAC 450 MPS Control Panel Installation Instructions Manual

Other manuals for 450 MPS Control Panel: Installation Manual, Installation Manual, Installation Manual
Manual is about: Gate Operator and Control Panel

Summary of 450 MPS Control Panel

  • Page 1

    Ist umweltfreundlich 100% altpapier pour la nature papier recyclé 100% for nature recycled paper 100% per la natura carta riciclata 100% para la naturaleza 100% papel reciclado c erme t a z ie n d a c e r tif ic a t a uni en iso 9001-085 450 mps 450 mps.

  • Page 2: General Safety Regulations

    9 english important notice for the installer general safety regulations 1) warning! Faac strongly recommends to follow these instructions literally for the safety of persons. Improper installation or misuse of the product will cause very serious damages to persons. 2) packaging material (plastic, po...

  • Page 3

    10 english 1 l op com cl cl com op lamp motor 1 motor 2 j2 j1 + — op — cl nc — 30 vcc fsw stop b — a — + — fswtx w.Light lock + — j3 230 v 50 hz 24 vdc 3 w fsw tx n 2 3 4 7 6 5 10 9 8 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 m1 c1 blu m2 c2 blu description and technical specifications t...

  • Page 4

    11 english safety devices and stop the movement of the gate leaves (fig. 3). The 450 mps card has an additional fail-safe device which serves to check that the n.C. Contact on the photocell receiver is working efficiently before any operation (can be disabled through bridge fig. 1 ref.15) . N.B. : i...

  • Page 5

    12 english 14 15 24 23 16 op — cl fsw + — fswtx op — cl fsw + — fswtx 14 15 24 23 16 1 2 5 4 3 1 2 rx tx 30vcc op — cl fsw + — fswtx + — 14 15 24 23 16 12 13 1 2 5 4 3 1 2 rx tx 14 15 24 23 16 12 13 30vcc op — cl fsw + — fswtx + — 1 2 5 4 3 1 2 rx tx 1 2 5 4 3 1 2 tx rx 14 15 24 23 16 12 13 30vcc op...

  • Page 6

    13 english stop – common ( - ) n.C. - stop contact: all devices (such as pushbuttons) which by opening a contact stop gate movement. To install several safety stop devices, connect the n.C. Contacts in series. N.B. If the stop devices are not connected, jumper stop and - inputs . B - single leaf ope...

  • Page 7

    14 english 1. Programming the microswitches automation programming is carried out by the microswitches (fig. 1 - ref. 9) as shown in the diagram below. 4) switch on the power. 5) send an open signal to input a (fig. 2) and check that the leaf opens. If the gate closes, invert the motor wires on the ...

  • Page 8

    15 english table 3/b opens leaves and recloses after pause time closed no effect (open inhibited) recloses leaves immediately open on pause recloses leaf immediately reopens leaves immediately reopens leaf immediately closing no effect (open inhibited) closes the leaf/leaves opening recloses leaves ...

  • Page 9

    16 english (*1) if residual pause time is less than 5 seconds on safety disengagement, the gate closes after 5 seconds. N.B.: effects of other active impulse inputs are shown in brackets table 3/e closed open closing no effect (open a/b inhibited) opens leaves or 1 leaf stopped opening no effect log...

  • Page 10

    Timbro del rivenditore:/distributor’s stamp:/timbre de l’agent:/ fachhändlerstempel:/sello del revendedor: le descrizioni e le illustrazioni del presente manuale non sono impegnative. La faac si riserva il diritto, lasciando inalterate le caratteristiche essenziali dell’apparecchiatura, di apportare...