Faber INCA HC SS Installation Instructions Manual - Warning
Version Hi-Lo SS 08/04 - Page 6
FOR INSTALLATIONS WITH LINERS
CUSTOM/WOOD
HOOD
STANDARD LINER
WARNING
!
When building a custom hood,
always follow all applicable
codes and standards.
1. The custom/wood hood must have a sturdy base (3/4" plywood recommended) to
accomodate the cut-out for the Inca HC SS. The base must be recessed to accomodate
the height of the Liner (see LINER DIMENSIONS on Page 4). The Liner attaches to the
bottom of the base using screws appropriate for the size and material of your custom/
wood hood. The Inca HC SS inserts into the cut-out in the Liner and base.
2. Position the rear section of the Liner so that it abuts the back edge of your custom/wood
hood. Using a pen, trace the outline of the pre-cut out. Remove the Liner and proceed
to MAKE YOUR CUT-OUTS on Page 7. Install both sections of the Liner and proceed
to INSTALL THE RANGEHOOD on Page 7.
INCA HC SS
The Inca HC SS can be used with
custom cabinetry and hoods 30"
wide and up. Choose either a
custom liner or our Standard Liner
designed for 30" and 36" wide
installations.
Liners create a perfectly-sealed,
non-combustible finish for the
underside of your custom/wood
hood.
The Standard Liners are made
up of two sections: a larger, rear
section (pre-cut out for insertion of
the Inca Smart) and a front section
for a total adjustable depth between
16" and 17
7/8"
.
! ! ! I M P O R TA N T N O T E :
YOU MUST REMOVE THE
ADDITIONAL PERFORATED
SECTION AROUND THE PRE-
CUT-OUT WHEN INSTALLING
THE STANDARD LINER WITH
THE INCA HC SS MODEL.
Consider the shape, size, and
weight of the Inca HC SS and
Liner to determine the configuration
of the custom/wood hood. See
RANGEHOOD AND CUT-OUT
DIMENSIONS AND LINER
DIMENSIONS on Page 4.