Faber INCA HC SS Installation Instructions Manual - page 7
Version Hi-Lo SS 08/04 - Page 7
INSTALL THE RANGEHOOD
1. Remove the rangehood from the carton and place on a
flat surface. Cover the surface to prevent accidental damage.
Remove all parts including the backdraft damper, plastic grille
and literature package before discarding the carton.
2. Remove the grease filters from the rangehood and set
aside. The grease filters are removed by pressing the handle
of the filter as indicated in FIGURE 6. When replacing, make
sure that the filters are properly positioned with the handles
in front and visible.
MAKE YOUR CUT-OUTS
1. Disconnect and move freestanding range from cabinet
opening to provide easier access to upper cabinet and rear
wall. Put a thick, protective covering over cooktop, set-in
range or countertop to protect from damage or dirt.
2. Determine and clearly mark with a pencil the center line
on the cabinet where the rangehood will be installed.
3. Determine and make all necessary cuts in the wall for
the ductwork. Install the ductwork before the rangehood.
4. Determine the proper location for the Power Supply
Cable. Use a 1 1/4" Drill Bit to make this hole. Install the
cable. Use caulking to seal around the hole. DO NOT turn
on the power until installation is complete.
5. Make the cut-out opening where the rangehood will be
installed (FIGURE 5).
FIGURE 5
CUT-OUT
27
5/8"
13
5/32"
FIGURE 6
3. Place the round damper into the exhaust opening of the
rangehood and press down.
4. The rangehood mounts to the cabinet by two spring
loaded brackets, one on each side of the rangehood. Lift the
rangehood into the cutout opening in the cabinet. Be careful
not to damage the cabinet, rangehood or other appliances.
5. Tighten the rangehood to the cabinet by rotating the
screws indicated in FIGURE 7 with a phillips screw driver.
FIGURE 7
6. Remove the cover from the field wiring compartment with
a phillips screwdriver. Feed the Power Supply Cable through
the electrical knockout. Connect the Power Supply Cable
to the rangehood cable. Attach the White lead of the power
supply to the White lead of the rangehood with a twist-on type
wire connector. Attach the Black lead of the power supply
to the Black lead of the rangehood with a twist-on type wire
connector. Attach the Power Supply Cable grounding lead to
the green screw provided. Using the 4 holes provided screw
the field wiring compartment to the wall or cabinet as dictated
by your Power Supply Cable location (screws not provided).
Replace the cover.
7. Replace the grease filters.
8. Connect the ductwork to the damper and seal all con-
nections with duct tape.
9. Turn the power supply on. Turn on the blower and light.
If the rangehood does not operate, check that the circuit breaker
is not tripped or the house fuse blown. If the unit still does
not operate, disconnect the power supply and check that the
wiring connections have been made properly.