Factor Electronics COMM-2 Owner's Manual - page 7
COMM-2 Mounting Instructions:
The COMM-2 includes an adjustable swivel mounting bracket that can be used to position the
COMM-2 at the correct mounting angle for the best performance.
1. Remove the “ Mounting Bolt” the COMM-2 horn will separate from the mount.
2. Position the mounting plate where the horn will be mounted. Use either wood screws or machine
bolts depending on the mounting surface to attach the mounting plate. Always make sure that the
COMM-2 is securely mounted to a flat surface. All three mounting screws/bolts must be used.
3. Re-attach the horn to the mount with the “Mounting Bolt” and tighten the mounting bolt securely
4. Loosen the “ Angle adjustment wing nut” to approx 75% but do not remove the wing nut. Push the
wing nut to release the wing bolt. Now the COMM-2 will rotate. Rotate to the desired angle and
tighten the “Angle adjustment wing nut”.
5. Connect the cables and test the COMM-2.
6. Mount the COMM-2 with the bell pointed directly at the monitoring area. See the example below:
COMM-2 Mounting Angle:
Mounting plate
Angle adjustment wing nut
Mounting bolt
info@factorelectronics.com
www.factorelectronics.com
This angle is too high
This is the correct angle
This angle is too low
7
7