Fagor 5CFB-30X Care & Instruction Manual - Working

Fixing the ornamental chimney  

* Before fixing the chimney, place the electric feeding 

equipment into the ornamental pipe and provide a hole for the 

air outlet if the appliance is used in its sucking version.  

Warning!  

Before connecting the flexible exhausting pipe to the motor, 

make sure the stop valve, which is on the air outlet of the 

motor, can swing.  

Sucking version  

* Fix the pipe-bearing stirrup (Fig.7Y) to the wall or ceiling by 

using the proper reinforcements and screws in equipment. 

Connect the range hood flange with the evacuation hole by 

using a proper pipe. Perform the electrical connections. The 

superior end of the pipe is to be fixed laterally to the pipe 

bearing (Fig.8Y) by using the two self-threading screws. Now 

mount the inferior chimney by inserting it through the front 

side of the range  hood and then turning it down until it is fixed 

inside (Fig.8).  

Filtering version 

* In the filtering version the air deviator is fixed through the 

screws supplied (Fig.9), by using the holes which are on the 

back of the upper telescopic section. Connect the flange of the 

appliance with the air deviator through an appropriate pipe. 

Connect the appliance with the electric mains. 

5

Mod. 5CFB-48X  –  5CFB-36X  –  5CFB-30X - Module - 

Luxury version (Fig. 10)  

A: Light switch on/off  

B: Motor switch on/off (1st rate level) 

C: 2

nd 

rate level switch  

D: 3

rd 

rate level switch  

E: 4

th 

rate level switch  

F: 10-minute timer.  

* An accurate maintenance guarantees good functioning and 

long-lasting performance.  

* Particular care is due to the grease filter panel. It can be 

removed by pushing its special handle toward the back-side of 

the range hood and turning the filter downwards so as to 

unfasten it from its slot (Fig.3B). To insert the filter just 

perform the opposite operation. After 30 hours of operation, 

the push button control panel will signal the saturation of the 

grease filter by lighting all the buttons. Press the timer button 

to reset 

. The grease filter should be cleaned by hand or in  

dishwashers at least every two months or depending on its 

use.  

* In case the appliance is used in its filtering version, the 

active coal filter (Fig.11) needs to be periodically replaced. 

The coal filter can be removed by removing the grease filter 

first (Fig.11B), and by pulling its special plastic tongue until it 

is unfastened from its slot. Re-insert the coal filter by reversing 

the steps. The coal filter needs replacing at least every six 

months, depending on the use.  

* To clean the appliance itself, tepid water and neutral 

detergent are recommended, while abrasive products should 

be avoided. For steel appliances specialized detergents are 

recommended (please follow the instructions indicated on the 

product itself to obtain the desired results).  

* Before replacing the lamps, disconnect the appliance from 

the electric mains. Remove the grease filter and the carbon 

filter, if it is inserted (Fig.8). Once the burnt out bulb is located, 

turn it counter-clockwise and replace it with a bulb of the same 

type.  

* To replace the halogen lamps, remove first the glass 

blocking ring (Fig.13A), by levering with a screw-driver and 

thus removing the opaque glass (Fig.13B) - when performing 

this operation hold the opaque glass carefully. Remove the 

lamp (Fig.13C) without touching it with uncovered hands. 

Replace it with another lamp of the same kind. After the 

replacement, re-insert the glass blocking ring and fasten it.  

WORKING 

MAINTENANCE