Fagor LVE-55 Installation Manual - Built-In Dishwashers

ENGLISH

pliance must stand firmly on the floor and be

as perpendicular as possible.

Level it accordngly. correcting any possible

irregularities in the floor.

This may be done by adjusting the height of

the feet at the bottom of the appliance (Figure

7) (0-20 mm).

A maximum 2% inclination level is allowed.

Door decoration

You can fit decorative panels to the door of

your DISHWASHER so that it matches the

surrounding decor.

This pannelling may be up to 4.5 mm thick.

Fitting the panels

1.- Remove the door frame from your dish-

washer by undoing the screws as shown

in Figure 3.

2.- Prepare the panel according to the mea-

surements given in Figure 3 (597 x 587

mm).

3.- Fit the panel you have chosen and screw

the frame back into place.

Once you have done this, proceed

with the water and electricity

supply connections according to the

instructions.

Built-in dishwashers

Introduction

Although they can also be used as free-

standing appliances, our BUILT-IN DISHWAS-

HERS are designed so that you can fit them

into your kitchen under the work surface.

You may easily adapt your dishwasher to the

decor and door alignment of the rest of your

kitchen by performing a few simple opera-

tions.

Dimensions

Figure 5 gives the measurements of your

dishwasher and the minimum requirements

for the kitchen units. These will help you in

the installation process.

If you want to put your dishwasher under the

kitchen work surface, you have to remove the

top cover by undoing the two screws shown in

Figure 4 and also remove the counter weight

located at the top of the machine. (Fig. 2)

You can use these same screws later to secure

your appliance to the kitchen work surface,

thereby ensuring the stability of the dishwas-

her.

Levelling and positioning

Refer to the section on levelling and positio-

ning for free-standing and panellable

dishwashers.

Door decoration

You can fit decorative panels to the door of

your DISHWASHER so that it matches the su-

rrounding decor.

This panneling may be up to 4.5 mm thick.

Panelling and adjusting the door

1.- Remove the door frame form your dish-

washer by undoing the screws as shwon in

Figure 6.

2.- Cut the decorative panel according to the

height required (h) to line it up with the

kitchen units either side.

3.- Take the door frame and cut it, by sawing off

the top ends, to the same height (h) as the

decorative panel.

4.- Adjust the lower door shim to the right

height (h).

5.- Fit the decorative panel to the door. At the

same time secure the frame and re-mark

the position of the new holes in the door.

Make the holes with a 3.25 mm drill bit.

Screw the frame back into place.

Note

If you want to fit your dishwasher into a row of

kitchen units with a single kickstrip, this is

possible, although you should bear the follo-

wing in mind:

1.- Remove the base (1) and the feet (2) by un-

doing the screws (according to Figure 1).

15