Fagor LVE-55 Installation Manual - Integrated Dishwashers

2.- Do not forget to change the adjustable feet

from Position A to Position B.

3.- Fit the kitchen unit kickstrip, sawing it to

the size required (according to Figure 4).

Once you have completed these tasks,

proceed with the electrical and

water connections according to the

instructions.

Integrated dishwashers

Introduction

Our INTEGRATED DISHWASHERS are de-

signed so that the door covering and the

control panel match the shape and size of 60

cm wide kitchen modules with a door and a

drawer at the top.

To do this, proceed as follows:

Dimensions

Figure 5 gives the measurements of your

dishwasher and the minimum requirements

for the kitchen units. These will help you in

the installation process

And remember if your dishwasher is an

integrated model, remove the brackets

located at the bottom of the dishwasher.

(Fig. 2).

Levelling and positioning

Refer to the section on levelling and positio-

ning for free-standing and panellable

dishwashers.

Integrating your dishwasher

Adjusting the height of the dishwasher

Turn the dishwasher feet B anticlockwise,

until the tp of the appliance comes into con-

tact wit the bottom of the kitchen work surfa-

ce (Figure 7).

This enables the DISHWASHER height to be

adjusted up to 870 mm.

Aligning the control panel (Figure 8)

This operation consists of aligning the control

panel of the dishwasher until it is at the same

height as the drawer panels of your kitchen

units.

Use the spacing pieces and screws provided

inside the appliance to carry out this opera-

tion.

If the height of the drawer panel is 110 mm, it

is not necessary to make any adjustments.

If it is higher, add as many spacing pieces as

necessary (spacer A = 5 mm, spacer B = 10

mm), forming 5 mm modules, to adjust the

height of the control panel to that of the

drawer panels of adjacent units (Figure 8).

Once you have done this, bear in mind that

when you fit the door panel, the bottom of it

must be in line with the kickplate of your

kitchen units.

Integrating your dishwasher

Once you have carried out the previous ope-

rations, proceed with the integration of your

dishwasher, as follows:

1.- Fit the protective plastic cover supplied

with the appliance to the underside of

your kitchen work surface (Figure 9).

This cover will prevent the condensation

generated during the operation of your

dishwasher from damaging the undersi-

de of your work surface.

2.- Using the template supplied with your

appliance, mark the points where the brac-

kets for fixing to the dishwasher are to go

on the back of the door panel (Figure 10).

Note

When preparing the front panel you must

take into account whetehr or not you have

increased the height of the control panel with

spacing pieces.

A)  If you have not, align reference point 0,

located on the top edge of the template,

with the top edge of the door panel.

ENGLISH

16