Fagor MPA-1000 Instructions For Use Manual - page 9
8
• Do not use aerosols while the appliance
is functioning.
• Do not cover the air inlet or outlet while
the appliance is functioning.
• Do not pull on the cord to remove the
plug from the mains.
• Do not hang the styler from its cord.
• Do not wind the cord around the
appliance.
• The electrical cord must not be replaced
by the user. If the cord is damaged, it
must only be replaced by a Technical
Assistance Service authorised by the
manufacturer.
• Do not switch on the styler if
- the electrical cord is damaged
- the appliance is not in perfect working
order
- it has been dropped
• When the appliance is no longer useful,
unplug it from the mains and then cut its
electrical cord.
3. SAFETY
The hair styler is equipped with a an
overload protection system which switches
off the appliance if overheating occurs (e.g.
if the air inlet or outlet are blocked). If the
styler switches off during use, turn the
switch to "0" and wait for 5 minutes approx.
Remove the cause of the obstruction and
switch it on again.
4. FITTING THE ACCESSORIES
Figs. 5 and 6
To fit the accessory onto the hair styler, turn
the
mark so that it is opposite the
mark (
); then fit the accessory onto
the appliance and turn it until the
mark is
opposite the
mark (
).
= The accessory is correctly fitted
onto the appliance.
To remove the accessory, press the "Push"
button, turn the appliance until the
mark
is opposite the
mark (
) and pull
on the accessory it to release it.
The accessories must be released by
pressing the "Push" button.
FUNCTIONING
Plug in the styler with the accessory fitted to
it.
Selector switch positions
0 = Off
1 = Medium temperature and speed
2 = High temperature and speed
= Cold air
This allows for quick cooling after styling.
Mod. MPA-600 (Fig. 7)
Mod. MPA-1000 y MPA-1000i (Fig. 8)
In this position, the appliance blows
out cold air when the button is
pressed and held down.
Fixed position for cold air without
needing to hold the button down.
MPA-1000i: Ion generator
(Fig. 9)
This function is used to give your hair a
better shine and to prevent static electricity.
To activate this function, push the switch
forward. The pilot light will come on.
6. WASTE ELIMINATION
The materials used in the
packaging, product and
accessories can be recycled.
Correct separation of waste
materials will allow recyclable
materials to be re-used.
When the appliance is no longer useful, you
should cut its cord to put it out of action and
dispose of it using a suitable waste
elimination procedure. For further information
on this matter, consult your local authorities.
5. CLEANING
Unplug the appliance before cleaning it.
Never submerge the appliance in water.
Remember to clean the air inlet grille regularly
with a brush to remove any dust and hair
which may have become trapped in it.
Clean the appliance with a damp cloth and
then dry it with a dry cloth.
Do not use abrasive cleaning products or
solvents.
Remove the accessories before cleaning them.
interior 25/6/04 13:35 Página 7