Fagor PLC-804 Instructions For Use Manual - page 12
11
5.DRYIRONING
1. Unwind and stretch out the steam tube
and mains cable.
2. Fill the boiler with tap water (refer to
the “Filling the Boiler” section).
3. Plug the appliance into a suitable
power point.
4. Press the LED on/off switch
(2)
5. Turn on the boiler switch
(3)
6. Turn the iron’s temperature control
(9)in a clockwise direction, select 1
point, 2 points or 3 points depending
on the recommendation made on the
garment’s label.
7. The pilot light
(6) will turn off when
the iron has reached the desired
temperature.
8. The appliance is ready to use.
9. Turn the iron’s temperature control
(9) in
an anti-clockwise direction until “Min”.
10. Turn off the LED on/off switch
(2).
11. Unplug the mains cable from the
power point.
12. When the appliance has completely
cooled down, store it in a safe place.
13. Unplug the mains cable.
14. When the appliance has completely
cooled down, store it in a safe place.
6.STEAMIRONING
1. Unwind and stretch out the steam tube
and mains cable.
2. Fill the boiler with tap water (refer to
the “Filling the Boiler” section).
3. Plug the appliance into a suitable
power point.
4. Switch it on.
5. Turn on the boiler switch.
6. Adjust the “steam level” to the
maximum level.
7. Turn the iron’s temperature control in
a clockwise direction. Select 1 point,
2 points or 3 points depending on
the recommendation made on the
garment’s label.
8. The “steam ready” LED indicator will
light up when it is ready for steam
ironing.
9. The pilot light turns off when the iron
has reached the desired temperature.
10. The appliance is ready to use.
11. Press the steam button for steam
ironing. If you want to use a constant
jet of steam, press the steam lock
button
(7).
12. Turn the iron’s temperature control in
an anti-clockwise direction until “Min”.
13. Turn the main switch off.
14. When the appliance has completely
cooled down, store it in a safe place.
IMPORTANT:When the fill-the-tank LED
indicator lights up, the boiler is empty. If
you wish to fill up the boiler, unplug the
appliance and let it cool down completely.
VERTICALSTEAMIRONING
This function supplies steam to remove
wrinkles from delicate garments, curtains or
other fabrics when they are hung up.
Note:
1. Donotapplysteamtoanygarmentor
fabricwornbyapersonoranimal.The
steamisataveryhightemperature.
2. Keepafewcentimetresawayfrom
delicatefabrics(manmadematerials,
silk,velvet,etc.),otherwisethefabric
maygetdamaged.
position. The pilot light
(6)will light up.
9. The “steam ready” LED indicator
(4)
will light up when it is ready for steam
ironing.
10. The pilot light will turn off when the iron
reaches the desired temperature.
11. The appliance is ready to use.
12. Press the steam button
(8) for a minute
to clean out the steam-generating
system.
13. The first time, begin to iron using an old
towel.
WARNING: To avoid burns or accidental
falls caused by the tube, the appliance has
some holders for hooking the cable.
These holders are inserted into their
respective holes, as shown in
figure3.