Fagor QF-1 Installation, Use And Maintenance Manual - page 18
www.Fagorcommercial.com
PAGE 18
REACH-INS OPERATIONAL SERVICE MANUAL / Rev.JUN. 2015
Never use high pressure water for cleaning the condenser coil. Water can damage the
electrical components located near or at the condenser coil. Do not place filter material in
front of condenser coil. This material blocks air-flow to the coil similar to having a dirty coil!
If you keep the Condenser clean, you will minimize your service expense and lower your
electrical costs. Failure to maintenance clean condenser coil can initially cause high
temperatures and excessive run times. Continuous operation with dirty or clogged condenser
coils can result in compress or failures. This will not be covered under warranty.
Neglecting the condenser coil cleaning procedures WILL VOID YOUR WARRANTY
To put back the condensing unit, slide in the unit carefully in. BE SURE THE DRAIN PIPEIS
LOCATED OVER THE DRAIN PAN. Replace front bottom panel.
5.3 GASKET
Gaskets require regular cleaning to prevent mold and mildew build up and to keep the
elasticity of the gasket. Gasket cleaning can be done with the use of warm soap and water.
Avoid the use of chemical cleaning products on gaskets as this can cause them to become
brittle and prevent proper sealing. Also, never uses hard tools or knives to scrape or clean the
gasket which could possibly tear the gasket and rip the bellows.
Gaskets can easily be replaced and do not require the use of tools or authorized service
personnel. To remove the gasket, pull the gasket towards you. To replace gasket, press the
gasket against the groove of the door the gasket will “snap” back into place.
5.4 DOORS/HINGES
During transportation the doors hinges may become loose. If the door(s) don’t look aligned,
tighten the screws that hold the hinge brackets to the frame of the unit. If the doors are loose
or sagging, this can cause the hinge to pull out of the frame which may damage the doors and
the door hinges. In some cases, this fix or adjustment may require a qualified service agent or
maintenance personnel.